Kuala Lumpur, Malaysia — Est. drafting since 1999
MEP Drafting Specialist
Fast, accurate and reliable AutoCAD drawings for mechanical, electrical and plumbing projects — from first markup to signed as-built.
MEP AutoCAD support, without the overhead.
i-draftsman is a freelance MEP drafting practice run by Jeff Teo. Contractors, consultants and developers use it as an on-demand drawing office — scaling drafting capacity up for a tender or a site submission without adding headcount.
Every sheet is produced by a drafter who has spent 25 years on real MEP projects, so drawings arrive already reasoned about: sensible routing, coordinated levels, layers and title blocks that match your standard.
- DisciplineMechanical · Electrical · Plumbing
- BaseKuala Lumpur, Malaysia
- EngagementPer-project · Negotiable scope
- Urgent workSupported
What gets drawn.
-
Ductwork layouts, sections and details, chilled-water schematics and equipment plant rooms — drawn to coordinate cleanly with structure and ceiling voids.
- Layout
- Section
- Details
- Schematic
-
Cold and hot water distribution, sanitary and waste stacks, and full isometric drawings for riser verification and site setting-out.
- Sanitary
- Cold water
- Isometrics
- Risers
-
Power, lighting and containment layouts, single-line diagrams and panel schedules — redrawn from consultant markups or built from scratch.
- Power
- Lighting
- Containment
- SLD
-
Combined services drawings that stack every trade into one sheet — clashes resolved on paper before they cost money on site.
- CSD layouts
- Level sections
- Clash resolution
-
Pool layouts, filtration pump rooms, circulation schematics and the technical details that make the plant room buildable.
- Pool layout
- Pump room
- Schematic
- Details
-
Gas system drafting: bulk tank arrangements, reticulation runs, isolation and appliance connections.
- Bulk tank
- Reticulation
- Isolation
-
Drawing sets for every stage of the job: design intent, tender issue, contract, shop drawings for fabrication, and final as-built records.
- Design
- Tender
- Contract
- Shop
- As-built
What comes off the board.
Illustrative sheets. Sample drawings for your discipline available on request.
Major project experience
- KLCC Lot C / Tower 3Kuala Lumpur
- Menara Maxis, KLCCKuala Lumpur
- Putrajaya Government Twin TowerPutrajaya
- Low Yat PlazaKuala Lumpur
- Burj DubaiDubai, UAE
- Palm Jumeirah MarinaDubai, UAE
- Delhi Metro RailDelhi, India
- Sidora Village Staff HousingQatar
- Samsung · Sato · Faber-CastellManufacturing
Four steps. No ceremony.
-
01
Submit input
Send a sketch, markup, PDF, CAD file or a written scope. Anything legible is a valid starting point.
-
02
Drafting
Drawings are prepared in AutoCAD to the agreed scope, layering and title block.
-
03
Review
You check the output and mark up comments. Corrections within scope are free.
-
04
Delivery
Final files issued for submission, coordination or site use.
Six reasons the work comes back.
Specialised in MEP
Not a general drafting shop. Mechanical, electrical and plumbing is the whole job.
Fast delivery
Urgent submissions supported. Deadlines are treated as the deliverable.
Free correction
Revisions within the agreed scope don't come with a second invoice.
Direct communication
You talk to the person drawing your sheets. No account layer in between.
Practical experience
25 years of site-tested MEP work informs every route and every section.
Reasonable pricing
Scope is negotiable and priced to the job, not to a rate card.